产品线选择: 所有产品 ------------------ 1-Wire®器件 放大器和比较器 汽车电子 接口与互连 微控制器 电源和电池管理 保护与隔离 无线、射频(RF)与电缆

应用笔记

应用笔记4219：充电器反接时，DS2784高边nFET保护器的保护电路 应用笔记4215：估算DS2712 NiMH电池充电器的开关速度 应用笔记4214：估算DS2715 NiMH电池充电器的开关速度 应用笔记4192：为DS2784独立式电量计添加热保护功能 应用笔记4188：DS278x电量计电流失调寄存器(COB)的校准 应用笔记4180：优化DS2715电池充电器的负载切换功能 应用笔记4134：利用0至1V模拟乘法器实现电池供电系统的精确功率管理 应用笔记4114：DS278x系列电量计中的RSGAIN校准 应用笔记4080：DS2703的通信流程图 App Note 4078: Extend Current-Sense Amplifier's Input Range Down to 0V 应用笔记4050：利用精密仪表放大器实现负压电流检测 应用笔记4043：如何在DS2784中存储电量计参数 应用笔记4034：三运放架构对仪表放大器的制约 应用笔记4002：理解倒装芯片和晶片级封装技术及其应用 应用笔记3999：充电电池和单机快速充电器概述 应用笔记3959：nMOS晶体管与DS2714的配合使用 应用笔记3906：用两个单向电流检测放大器组成一个双向电流检测放大器 App Note 3889: Using the DS2746 to Identify a Battery-Pack Based on an Identification Resistor 应用笔记3888：带有输入串联电阻的电流检测放大器的性能 应用笔记3883：高可靠性系统中电流检测的实际考虑 App Note 3727: Storing Battery Fuel Gauge Parameters in the DS2781 应用笔记3669：新的功率检测电流断路器 应用笔记3607：用USB为电池充电 App Note 3584: Storing Battery Fuel Gauge Parameters in DS2780 应用笔记3489：DS91230 USB适配器在Windows® 98系统中的安装 App Note 3463: Getting Started with the DS2780 应用笔记3407：从DS2761升级到DS2762 应用笔记3406：合理的DS2780线路板布局降低电流测量失调误差 应用笔记3388：用DS2711/12检测原电池 应用笔记3377：Maxim晶片级封装安装指南 应用笔记3336：笔记本电脑转接器 App Note 3225: Waking up a DS2761/DS2762 应用笔记3168：消除对于电池电量计的误解—精确的电池监测可以提高无线手机和其他产品的性能 应用笔记3092：DS2740U应用电路替代方案可减小电流的测量偏差 应用笔记3065：DS2762的上电状态 应用笔记2420：与Microchip PICmicro微控制器之间的1-Wire通信 应用笔记2416：DS27xx电量计电路板布局技巧，实现测量误差最小化 App Note 2096: DS2740 High-Precision Coulomb Counter Reference Design 应用笔记2055：±1%精度的功率计 App Note 2044: Simple Current Limiter for DS2770-Based Chargers App Note 1949: Bi-directional Current-Sense with Single Output App Note 1934: Add High Voltage Capability to the MAX471/MAX472 High-Side Current Sense Amplifiers App Note 1927: Designing a Pulse Charger for Use With Unregulated Power Supplies App Note 1919: Increasing the Fuel Gauge Dynamic Range App Note 1867: Optocoupler Extends High-Side Current Sensor to 1kV App Note 231: Compensating for Sense Resistor Self Heating App Note 227: Charge Efficiency and Cell Aging Effects of the DS2770 Li+ Pulse Charger vs. Linear Chargers App Note 224: Calibrating the Offset Register of the DS2761 App Note 223: DS2770-Based Charging with Unregulated Sources App Note 222: Using the DS2770 as a 3-Cell NiMH Charger App Note 221: DS276x Product Comparison App Note 214: Using a UART to Implement a 1-Wire Bus Master App Note 211: Handset-Based Fuel Gauging App Note 201: DS2770-Based Battery Monitor and Charger Reference Design App Note 197: Sense Resistor Power Dissipation 应用笔记187：1-Wire搜索算法 应用笔记192：DS2480B串行接口1-Wire线驱动器的使用 App Note 189: Advanced Rechargeable Lithium Battery Pack Fuel Gauge, Protection, and Timekeeping Solution 应用笔记159：绝对可靠的1-Wire通信 App Note 165: Interfacing the DS2760 1-Wire High-Precision Li-Ion Battery Monitor and Protection IC in a Microcontroller Environment 应用笔记148：1-Wire网络可靠设计指南 App Note 143: Multiple Battery Pack Applications Using the DS2760 or DS2761 App Note 128: Testing and Calibrating a DS2760 Li-Ion Battery Monitor and Protector Based Circuit App Note 138: Using the DS2760 or DS2761 Battery Monitor in Multiple-Cell Applications App Note 121: Inaccuracies of Estimating Remaining Cell Capacity with Voltage Measurements Alone App Note 131: Lithium-Ion Cell Fuel Gauging with Maxim Battery Monitor ICs App Note 746: High-Side Current-Sense Measurement: Circuits and Principles App Note 1180: High-Accuracy Current-Sense Amplifier Enables Current Sensing and Current Sharing App Note 981: Choices for Battery-Charging System Architecture App Note 344: Input Current Limiting in Battery Chargers for Mobile Computing Applications 应用笔记126：用软件实现1-Wire通信 应用笔记2563：锂离子电池保护电路